Faucet Installation Pocatello ID homeowners can count on starts with shutting off the right valve, checking the supply lines, and setting the new fixture so it never drips. We install kitchen and bath faucets across Bannock County, from older homes near Old Town to newer builds out by Pocatello Creek. If your faucet is leaking, corroded, or just outdated, we can swap it out fast and leave the countertop looking clean.
Faucet installation Pocatello ID is the process of removing an old or failing faucet, prepping the mounting surface, connecting new supply lines, and pressure-testing every joint before the water goes back on. It sounds simple until you get under a 1970s sink with seized shutoff valves and copper piping that has been sweating for decades. We handle kitchen, bathroom, and shower faucets, plus the shutoff valves and PEX or copper connections behind them.
Most calls we get in Pocatello start the same way: a drip that won't stop, low water pressure on one side, or a handle that spins without changing temperature. In homes around University Area and Highland, hard water has usually eaten through the cartridge long before the finish wears out. If you have been searching for faucet install Pocatello Idaho near me and want it handled in one visit, we bring the parts, the tools, and the experience to do it right.
Every faucet job is different, but here is what we cover on a standard installation. If your job needs something outside this list, we tell you before we start and quote it separately.
We pull the existing faucet, disconnect the supply lines, and clean off the old silicone caulk and any mineral buildup around the mounting holes. If the old faucet is corroded in place, we use an oscillating multi-tool to cut it free without damaging the countertop.
We install new braided stainless supply lines on both hot and cold. Old rubber or plastic lines are the number one cause of under-cabinet leaks, and they cost very little to replace while the faucet is already off.
We test both shutoff valves before and after the install. If a valve will not close fully or is seized, we replace it. That is the single most common add-on we see in older Pocatello homes, and it prevents a flood later.
We run a fresh bead of silicone caulk around the base of the faucet and the sink edge. That keeps water from running under the rim and into the cabinet, which is where mold and mildew start.
We turn the water on, run hot and cold, and check every joint with a dry paper towel. If anything weeps, we fix it before we leave. Then we wipe down the counter, haul off the old faucet, and walk you through what we did.
You call, we ask what kind of faucet, what kind of sink, and whether the shutoff valves actually turn. That five-minute conversation tells us whether to bring a pipe wrench, a plumber's snake, or a replacement valve kit. We give you a price range on the spot.
First thing on site, we shut off the supply, open the faucet to drain the line, and lay down towels and a bucket. If the shutoff valve is seized, we replace it before touching the faucet. That step alone prevents most of the water damage we see in Pocatello homes.
We pull the old faucet, scrape off the old silicone caulk, and clean the mounting holes. If the countertop is quartz or stone, we tape the surface first so nothing gets scratched. We check the supply lines and the drain tailpiece while everything is exposed.
The new faucet goes in with new washers, new supply lines, and a fresh bead of silicone caulk around the base. We hand-tighten, then finish with a basin wrench so nothing gets over-torqued. Expect 60 to 90 minutes for a standard bathroom faucet, longer for a kitchen with a sprayer.
We turn the water back on, run hot and cold, check every joint with a dry paper towel, and watch for drips under the cabinet. If anything weeps, we fix it before we leave. Then we haul off the old faucet and wipe down the counter.
You call, we ask what kind of faucet, what kind of sink, and whether the shutoff valves actually turn. That five-minute conversation tells us whether to bring a pipe wrench, a plumber's snake, or a replacement valve kit. We give you a price range on the spot.
Reaches the mounting nuts behind a sink where a standard wrench will not fit. Essential for tightening a faucet without scratching the countertop or stripping the nut.
Used on older supply lines and shutoff valves that are seized. Gives us the leverage to break a stuck fitting loose without cracking the pipe.
Cuts a corroded faucet free or trims a countertop opening when the new faucet needs a slightly larger hole. Cleaner than a saw and easier to control in a tight cabinet.
Applies a consistent bead of silicone caulk around the faucet base and sink rim. A clean caulk line is what keeps water out of the cabinet.
Checks the cabinet floor and back panel for hidden moisture after a leak. Tells us whether the wood is dry enough to leave or needs more attention.
Clears a clogged drain tailpiece or P-trap while we have the sink apart. Saves you a second service call for a slow drain.
A two-handle chrome faucet with a stripped hot-side cartridge and a seized shutoff valve. The cabinet floor showed old water staining and the caulk line around the sink was black with mildew.
After: New single-handle Moen faucet, two new quarter-turn shutoff valves, new braided supply lines, and a fresh silicone caulk line. Total job time was two hours and fifteen minutes. The cabinet floor was dried and treated before we closed up.
Book this service →A 15-year-old kitchen faucet with a broken sprayer diverter and low pressure on the hot side. The supply lines were original plastic and starting to stiffen.
After: Installed a Delta pull-down faucet with a new sprayer hose, new braided stainless supply lines, and a cleaned aerator. Hot-side pressure came back to full flow. Job took just under three hours including cleanup.
Book this service →
Two matching builder-grade faucets with dripping handles and loose bases. The countertop holes were slightly undersized for the new trim the homeowner had picked out.
After: Opened both holes with an oscillating multi-tool, installed two Kohler faucets with new supply lines, and re-caulked both sinks. Both faucets tested dry after a full minute of hot and cold run time.
Book this service →Most faucet calls come down to one of a handful of failures. Here is what we see most often and how we handle it.
Ask a pro →We pull the cartridge, inspect the valve seat, and either replace the cartridge or install a new faucet. Most drip repairs take under an hour, and we test the handle in both directions before we call it done.
We remove the aerator, flush the supply line, and check the cartridge. Pocatello's hard water leaves calcium deposits that choke flow over time. A new cartridge and a cleaned aerator usually restore full pressure the same day.
We trace the leak with a moisture meter, replace the failed supply line or drain gasket, and dry the cabinet. If the shutoff valve is the source, we replace it while we are under there.
We replace the cartridge or the faucet, depending on the model. If the valve body is damaged, we recommend a shower valve replacement or a full faucet swap rather than chasing a repair that will not hold.
Most faucet installations in Pocatello run $180 to $450 in 2026, including labor and new supply lines. A basic bathroom faucet swap sits at the low end. Kitchen faucets with a pull-down sprayer, or jobs that need a new shutoff valve or a corroded stub-out replaced, land at the higher end. If you supply the faucet yourself, we deduct the fixture cost from the quote.
A standard bathroom faucet takes 60 to 90 minutes. A kitchen faucet with a sprayer, disposal air gap, or a tight cabinet usually takes two to three hours. If the shutoff valves are seized or the countertop needs modification, add another hour. We schedule most jobs as a single visit and test everything before we leave.
You can, and plenty of homeowners do. The job goes wrong when the shutoff valve will not close, the supply line nut is seized, or the countertop hole is the wrong size for the new faucet. If any of those happen, you are looking at a shutoff valve replacement or a countertop modification. That is when calling a licensed plumber is cheaper than the damage from a failed DIY attempt.
Moen and Delta are the two we install most, because their cartridges are easy to source and hold up to Pocatello's hard water. Kohler and Grohe make excellent higher-end fixtures if you want a specific finish. American Standard is a solid budget option. The bigger factor is the cartridge material and the finish, not the badge on the box.
One call gets you a price, a time window, and a crew that shows up. We are licensed, insured, and we warranty our faucet installation labor for 12 months. Call BathFlow Remodeling at +1 (986) 336-9053 and we will get your faucet swapped out this week.
Get a Free Quote +19863369053 →Call us or send a message and we will get back to you the same business day. We schedule estimates Monday through Friday and can usually get to a Pocatello address within a few days. Tell us what is going on with the bathroom and we will tell you what it takes to fix it.