Tear-out and disposal
We remove the old tub, surround, and any failing backer board, then haul it all away. Subfloor inspection with a moisture meter is included, and we photograph anything we find behind the wall before quoting a repair.
Tile, tubs, and waterproofing done code-correct the first time
Bathtub remodeling Pocatello ID built to last decades
If your tub is cracked, stained, or just plain worn out, bathtub remodeling Pocatello ID homeowners trust starts with a straight answer about what your bathroom actually needs. We tear out the old surround, fix whatever the last install hid, and set a new tub or shower base on a properly waterproofed substrate. Most jobs wrap in three to seven days, and you get a written price before we swing a hammer.
Careful work. Honest options.
About this service
What bathtub remodeling Pocatello ID really involves
bathtub remodeling Pocatello ID is a full tear-out and rebuild of the tub, surround, and wet-wall assembly, not a cosmetic patch. We pull the old tub, inspect the subfloor and framing for rot, replace any soft wood, then set a new American Standard or Kohler tub on a level bed of mortar. From there it is cement backer board, a waterproofing membrane, and tile set with spacers and a grout float. Every joint gets silicone caulk, not grout, because grout cracks where walls meet.
Older homes around Old Town and the University Area often hide water damage behind the tub skirt, especially when a leaking shower valve has been dripping for years. We check the subfloor with a moisture meter before anything goes back in. If you have been putting off a bathtub renovation Pocatello Idaho because you dread the mess, we plastic off the doorway, haul debris daily, and keep the rest of your house usable. A typical bathtub replacement Pocatello ID runs three to five days once materials land.
- ✓ Stop hidden water damage
- ✓ Fixtures that actually match
- ✓ Easier cleaning, fewer repairs
- ✓ Add real resale value
What's included
What our bathtub remodeling includes
Every tub remodel we quote covers the tear-out, the wet-wall rebuild, and the finish work. We list what is in the price up front so you can compare quotes apples to apples instead of guessing what a competitor left out.
New tub and drain
The price includes a new tub set on a mortar bed, a new drain assembly, and a new overflow. We level the tub so it does not flex or squeak, and we test the drain with a full tub of water before closing up.
Valve and supply lines
We replace the shower valve with a Moen, Delta, or Grohe unit and run new PEX or copper supply lines. Old galvanized pipe gets swapped out so your pressure and temperature stay steady.
Waterproofing and tile
Cement backer board, a waterproofing membrane, and porcelain or ceramic tile are included, along with grout and silicone caulk at every change of plane. We set tile with spacers and a laser level so the walls are plumb and the joints are even.
Exhaust fan check
We test your existing exhaust fan and confirm it vents outside. If it is undersized or venting into the attic, we quote a replacement so moisture leaves the room instead of feeding mold and mildew on the ceiling and grout.
How it works
How our bathtub remodel process runs
We measure your alcove, check the drain and valve locations, and look at the subfloor through the access panel. You get a written price the same day, broken out by tub, tile, plumbing, and labor, so you can see exactly where the money goes.
We pull the old tub and surround, usually in half a day. That is when we find the real story: soft subfloor, a leaking shower valve, or a clogged drain line. We show you photos before we quote any repair so there are no surprises.
New PEX or copper supply lines, a fresh drain assembly, and a new valve go in first. Then cement backer board, a waterproofing membrane, and a laser level check on every wall. This is the stage that decides whether the job lasts.
We set the tub on a mortar bed so it does not flex, then tile the surround with spacers for even joints. Grout goes in after 24 hours of cure time, and silicone caulk seals the tub-to-tile seam. Most surrounds take two days.
We run hot water through the valve, check for leaks at every connection, test the drain, and confirm the exhaust fan pulls air. You walk the job with us, and we leave the room broom-clean. Warranty paperwork comes with you that day.
STEP 01On-site measure
We measure your alcove, check the drain and valve locations, and look at the subfloor through the access panel. You get a written price the same day, broken out by tub, tile, plumbing, and labor, so you can see exactly where the money goes.
Tools & methods
Tools and methods we bring to the job
Wet saw
Cuts porcelain and ceramic tile cleanly without chipping the glaze, which matters on the visible edges around a tub surround.
Laser level
Sets a true horizontal line for the first course of tile and checks that every wall is plumb before backer board goes up.
Moisture meter
Reads the subfloor and framing after demo so we know whether we are setting a new tub on dry wood or replacing rot first.
Oscillating multi-tool
Cuts backer board, trims framing, and removes old caulk and thinset in tight corners where a full-size saw will not fit.
Grout float and tile spacers
Packs grout into joints evenly and holds consistent spacing so the surround reads straight across the whole wall.
Caulking gun
Lays a clean silicone bead at the tub-to-tile seam and every inside corner, which is where most leaks start.
Real results
Before and after.
Bathtub Remodeling
Rusted 1952 cast iron tub in Old Town
A cast iron tub with rust bleeding through the enamel and tile falling off the wall behind it. The subfloor under the tub was soft from a slow valve leak, and the surround had no waterproofing behind the tile.
After: New American Standard acrylic tub on a mortar bed, porcelain tile over cement backer board with a bonded membrane, and a new Moen valve. Job took five days, and the subfloor was replaced and sealed before the tub went back in.
Book this service →
Bathtub Remodeling
Leaking valve behind a Highland Area surround
A slow drip from the shower valve had soaked the backer board and framing for months. The homeowner smelled mildew before seeing any water, and the grout at the tub line was black.
After: We opened the wall, replaced the valve body with a Delta unit, rebuilt with new backer board and a waterproofing membrane, and re-tiled the surround. Pressure-tested the valve before closing up. Four days total.
Book this service →
Bathtub Remodeling
Tub-to-shower conversion near Pocatello Creek
A standard 60-inch builder-grade tub and fiberglass surround in a 5x8 bathroom. The homeowner wanted a walk-in shower but did not want to move walls or lose floor space.
After: We removed the tub, re-routed the drain to a corner location, built a low-curb shower with porcelain tile, a bench, and blocking for grab bars. Glass door installed after tile cure. Six days start to finish.
Book this service → Problems we solve
Bathtub problems we fix in Pocatello homes
Most tub remodels start with a symptom the homeowner has been living with for months. Here is what we see most often and how we handle it.
Ask a pro →Cracked tile grout and mold at the tub line
We remove the failed tile and grout, replace any soft backer board, and rebuild with a waterproofing membrane. Silicone caulk at the tub-to-tile seam replaces grout, which is what cracked in the first place.
Leaking shower valve dripping inside the wall
We open the wall, replace the valve body with a Moen or Delta unit, and re-tile the access. We pressure-test the new valve before closing up so you know the leak is gone.
Tub flexes or squeaks when you step in
We pull the tub, level the alcove, and set the new tub on a mortar bed so it does not move. The drain and overflow get reconnected and tested with a full tub of water.
Low water pressure at the tub spout
We replace the supply lines with PEX or copper, swap the cartridge, and check the shut-off valves. Most Pocatello homes see full flow restored the same day we finish the rough-in.
Proof you can check
Licensed, insured, and accountable
- State of Idaho Plumbing License · State of Idaho Division of Occupational and Professional Licenses
- EPA Lead-Safe Certified Firm · U.S. Environmental Protection Agency
- TCNA Tile Installation Certification · Tile Council of North America
- OSHA 10 Safety Training · Occupational Safety and Health Administration
- Licensed, Insured, and Bonded in Idaho · State of Idaho
Most full tub-and-surround remodels in Pocatello run $4,500 to $11,000 in 2026, depending on tub type, tile choice, and whether we find water damage. A simple acrylic tub swap with a new valve and surround lands near the low end. Cast iron tubs, custom tile, and hidden subfloor repair push toward the top. We give you a written range after measuring.
Refinishing costs $450 to $900 and buys you three to five years if the tub is structurally sound. Replacement runs $1,200 to $3,500 for the tub alone and lasts decades. If your tub flexes when you step in, has rust through the enamel, or the surround is failing, replacement is the better money. We will tell you straight which one your tub needs.
A standard tub-and-surround remodel takes three to five working days. Add two days if we replace the valve and drain, and up to a week if we find subfloor rot or need to re-route supply lines. Tile cure time is built into that schedule, so we are not rushing grout. You get a day-by-day timeline before we start.
Acrylic tubs handle Pocatello's dry winters and hard water best for the money, with cast iron and enameled steel lasting longest if you can handle the weight and cost. For surrounds, porcelain tile over cement backer board and a waterproofing membrane outlasts any prefab panel. We spec American Standard, Kohler, and Toto tubs most often because parts stay available.
Ready when you are
Get your bathtub remodeling Pocatello ID quote
We measure, we price it in writing, and we show up when we say we will. Licensed, insured, and bonded in Idaho. Call BathFlow Remodeling at +1 986-336-9053 and we will schedule your on-site estimate this week.
Get Free Estimate +19863369053 →
Request an appointment
Contact our Pocatello bathroom crew
Call us or send a message and we will get back to you the same business day. We schedule estimates Monday through Friday and can usually get to a Pocatello address within a few days. Tell us what is going on with the bathroom and we will tell you what it takes to fix it.
Call anytime+19863369053Email the officeinfo@bathroomremodelpocatelloid.com
Office hoursOpen 24 hours · 7 days a week