Removal and disposal
We remove the old cabinet, doors, and caulk, protect the floor, and haul the debris away. Old cabinets do not sit in your driveway, and the wall cavity is left clean enough to inspect before anything new goes in.
When you need bathroom cabinet installation Pocatello ID homeowners trust, BathFlow Remodeling handles the whole job: tear-out, framing corrections, moisture checks, and a level set that keeps doors and drawers gliding for years. We serve Bannock County with cabinet install Pocatello Idaho that accounts for the humidity swings, older plumbing walls, and tight layouts common in local homes. Call today for a straight answer on scope and price.

Bathroom cabinet installation Pocatello ID is the measured removal and replacement of vanity, wall, and linen cabinets, including shimming to level, anchoring to studs, sealing against moisture, and reconnecting plumbing and electrical where needed. We check the wall with a stud finder and laser level before anything goes in, because a cabinet that looks fine on day one can sag once a quartz countertop and a full sink load sit on it. Old caulk and soft drywall come out first, and we probe the surrounding area with a moisture meter to catch hidden water damage before it gets covered up.
Pocatello homes deal with dry summers and cold winters, and that swing works on cabinet joints and caulk lines. In older houses near Old Town Pocatello and the University Area, we often find out-of-square walls and legacy copper piping that needs attention before a new cabinet goes in. If you have been searching bathroom cabinets near me Pocatello and getting vague answers, we walk the room, measure the actual opening, and tell you what will fit. That is also where we price bathroom cabinet installation Pocatello ID cost honestly, with no surprises after demo.
Our standard cabinet install covers removal, wall prep, blocking, level set, and reconnect of the sink and faucet. Countertop and tile work are quoted as part of the same scope when you want them. Here is what is in the base job so you can compare quotes fairly.
We remove the old cabinet, doors, and caulk, protect the floor, and haul the debris away. Old cabinets do not sit in your driveway, and the wall cavity is left clean enough to inspect before anything new goes in.
A moisture meter reading and stud finder pass come first. We add wood blocking where studs are missing and correct minor out-of-square framing so the cabinet has solid material to fasten into, not just drywall.
We shim and fasten the cabinet through the back rail into studs, then check with a laser level. Doors and drawers are adjusted on site so nothing rubs, and the cabinet base is set to clear floor splash.
Supply lines, drain, and faucet go back in with new seals where needed. We run water and check under the cabinet for drips before closing out. PEX piping or copper piping adjustments are handled under our State of Idaho Plumbing License.
Silicone caulk seals the countertop seam and any wet edge. Trim and paint touch-ups finish the cabinet-to-wall joint so the install looks built-in, and we leave care notes for keeping the caulk line sound.
We measure the opening, check wall square, and locate studs and shutoffs. A moisture meter reading tells us whether the drywall behind the old cabinet is sound. You get a written scope and a price before we schedule, usually within one visit.
Old cabinets, caulk, and damaged drywall come out. We cap or shut off water at the valve, protect the floor, and inspect the wall cavity for soft framing or old leaks. If we find water damage, we show you photos and fix it before new cabinets go in.
Cabinets need solid wood to bite into. We add blocking where studs are missing, correct out-of-square walls, and set the base so the cabinet sits level front to back. This step is why our installs stay tight after a year of Pocatello humidity swings.
We set the cabinet, shim to level, and fasten through the back rail into studs. Doors and drawers get adjusted on site. Countertop, sink, and faucet go back in the same visit when the scope allows, with silicone caulk sealing every wet seam.
We test every door, drawer, and water connection, then run the faucet and check under the cabinet for drips. Trim and paint touch-ups finish the edges. We walk the room with you, hand over care notes, and haul the old cabinets away.
We measure the opening, check wall square, and locate studs and shutoffs. A moisture meter reading tells us whether the drywall behind the old cabinet is sound. You get a written scope and a price before we schedule, usually within one visit.
Sets a true reference line for cabinet height and countertop plane so the box is level front to back and side to side.
Locates framing for blocking and fastening, which is what keeps a cabinet from pulling out of drywall under load.
Reads the wall and cabinet base for hidden water before new material covers it up.
Cuts caulk lines and trim cleanly at cabinet edges without tearing drywall or tile.
Applies silicone caulk at wet seams and countertop edges for a sealed, even bead.
Handles shutoff and supply line work during the sink and faucet reconnect.

A 1990s vanity had pulled away from the wall, the doors rubbed the frame, and the drywall behind it read high on a moisture meter. The shutoff valve was seeping and the cabinet base was soft.
After: We replaced the valve, added blocking into the studs, and set a new cabinet with a sealed base. Doors and drawers were adjusted on site. The moisture reading dropped to normal, and the new countertop seam was sealed with silicone caulk.
Book this service →
A single small vanity left a couple with no storage, and towels ended up on the floor. The wall was straight but the layout wasted space next to the shower.
After: We installed a dual-sink cabinet run with a linen tower, gaining about four cubic feet of usable storage. The countertop was templated after the cabinet was level, and the outlet was moved so nothing was blocked.
Book this service →
A rental unit had a cabinet with a swollen base from a slow supply line leak, and the tenant was moving out in a week. The outlet behind the cabinet was also outdated.
After: We replaced the supply line, set a stock cabinet on a sealed base, and updated the outlet under our State of Idaho Electrical License coverage. Demo and set happened on consecutive days so the unit was ready for the next tenant.
Book this service →Most cabinet replacements start with a problem the homeowner already noticed: a soft toe-kick, a door that will not close, or a smell that keeps coming back. We fix the cause, not just the symptom, so the new cabinet lasts.
Ask a pro →We shut off the supply, open the cabinet base, and trace the leak with a moisture meter. The valve or supply line gets replaced, the wet material comes out, and the new cabinet goes in on a sealed base with a dry wall behind it.
We pull the cabinet, add blocking into the studs, and reset it with a laser level and shims. Hinges and glides are adjusted after the box is true, so the doors close flush and stay that way.
We check the exhaust fan and duct during the cabinet job, seal seams with silicone caulk, and recommend a fan sized for the room. Fixing ventilation is what keeps the new cabinet and caulk line clean.
We measure the actual opening and plan drawer depth, toe-kick, and a linen tower where space allows. Custom bathroom cabinets Pocatello Idaho layouts gain real storage without crowding the toilet or shower clearance.
Most single-vanity installs run $450 to $1,200 in labor, with the cabinet itself adding $300 to $2,500 depending on stock versus custom. A full wall of cabinets or a layout change pushes labor toward $1,800. Typical 2026 pricing in Pocatello also reflects plumbing and electrical reconnects, which we quote upfront.
Plywood-box cabinets with a moisture-resistant finish outperform particleboard in Pocatello bathrooms, where winter humidity swings are hard on joints. We recommend sealed plywood or high-density fiberboard with edge sealing, plus silicone caulk at every wet seam. Brands like Kohler and American Standard pair well with these boxes, and a quartz countertop sheds splash better than laminate.
A single vanity swap takes one day, start to finish. A full wall of cabinets with countertop and sink reconnect runs two to three days, and custom bathroom cabinets Pocatello Idaho orders add two to four weeks of lead time before install. We schedule demo and set on consecutive days so your bathroom is not torn up longer than needed.
You can hang a stock cabinet, but the parts that fail are the ones homeowners skip: blocking behind drywall, moisture checks, and code-correct plumbing reconnects. A DIY install that misses a slow valve leak can rot a cabinet in one season. If you want the work warrantied and the reconnect done under a State of Idaho Plumbing License, bring in a pro.
We measure the opening, check the wall for moisture, and give you a clear price before any cabinet comes out. Licensed, insured, and warrantied work across Pocatello and Bannock County. Call now and we will get your install on the schedule.
Get a Free Quote +19863369053 →Call us or send a message and we will get back to you the same business day. We schedule estimates Monday through Friday and can usually get to a Pocatello address within a few days. Tell us what is going on with the bathroom and we will tell you what it takes to fix it.