Old top removal
We shut off the water, disconnect the faucet and drain, and pull the old top without damaging the cabinet box. The old slab gets hauled away and disposed of. If the cabinet has rot, we show you before we proceed.
Quartz, granite, and solid surface tops cut to fit your vanity
Bathroom countertop installation Pocatello ID done right the first time
When you need bathroom countertop installation Pocatello ID homeowners can count on, we template, cut, and set the top so it lands level, sealed, and plumbed the same week. We handle quartz countertop installation Pocatello ID, granite, and laminate, plus the sink cutout, faucet swap, and silicone caulk line. Old tops come out, new ones go in, and your vanity looks finished instead of half-done.
Careful work. Honest options.
About this service
What bathroom countertop installation Pocatello ID actually involves
Bathroom countertop installation Pocatello ID is the removal of your old vanity top and the fabrication and setting of a new one, cut for your sink, faucet, and backsplash. We pull the old top, check the cabinet box for square and rot, then template the new slab. A wet saw or oscillating multi-tool handles the sink cutout; a laser level keeps the front edge true. The top gets set on a bead of silicone caulk, the faucet and drain get reconnected, and we water-test before we pack up.
Most Pocatello bathrooms we walk into are 30 to 60 years old, and the vanity top is usually the first thing to fail. Laminate delaminates near the sink, tile grout turns black, and particleboard swells after a slow leak. If you have been searching countertop install Pocatello Idaho near me, that is usually the reason. We also see a lot of cracked tile grout and mold and mildew along the backsplash seam, which is a sign water has been getting behind the top for a while.
- ✓ Non-porous, easy-clean surface
- ✓ Correct sink and faucet fit
- ✓ Water damage stopped early
- ✓ Better daily routine
What's included
What our countertop install Pocatello Idaho service includes
Every job includes removal, templating, fabrication, setting, plumbing reconnection, and cleanup. Add-ons like a new faucet, sink, or taller backsplash are quoted separately so you can see the cost before you decide.
Templating and leveling
We template the actual cabinet box, not a spec sheet, and check it with a laser level. Out-of-square boxes get shimmed so the new top sits flat. This is what keeps a sink cutout from cracking later.
Fabrication and edge polish
The slab is cut to template, the sink opening is cut, and the edge profile is polished. We cut outside or with a wet saw to keep dust out of your home. Undermount sinks get a polished reveal.
Setting and sealing
The top is set on a continuous bead of silicone caulk, the backsplash is attached, and the seam is smoothed. We seal the sink cutout edges and the wall joint so water cannot wick into the cabinet.
Plumbing reconnection
Faucet, drain, and supply lines get reconnected and tested. We check the shutoffs and the PEX or copper lines while the cabinet is open. Hot and cold both get run before we call the job done.
Water test and cleanup
We fill the sink, watch the drain and supply connections, and wipe down the room. You get a walkthrough of the finished top and the care instructions for your material before we leave.
How it works
How our countertop install Pocatello Idaho process runs
We measure your vanity box, check it for square with a laser level, and confirm sink and faucet placement. If the cabinet is out of level, we shim and shim until the top sits flat. This visit takes about 30 to 45 minutes, and you get a written price before we order anything.
You pick the slab and edge profile. Quartz, granite, and solid surface are the three we install most. We bring samples so you can see how the color reads against your tile and lighting. Lead time on most slabs runs 5 to 10 business days.
We cut the slab to your template, polish the edge, and cut the sink opening. A wet saw keeps the cut clean and dust down. Undermount sinks get a polished reveal; drop-ins get a bead of silicone caulk under the rim. This stage takes one to two days in the shop.
On install day we shut off the water, pull the old top, and set the new one. The faucet and drain get reconnected, and we check the PEX or copper supply lines while we are in there. Setting and plumbing usually runs 3 to 5 hours for a single vanity.
We run hot and cold, fill the sink, and watch the drain and supply connections for drips. The silicone caulk line gets smoothed, the backsplash gets set, and the room gets wiped down. You get a walkthrough before we leave, and we haul the old top away.
STEP 01Measure and template
We measure your vanity box, check it for square with a laser level, and confirm sink and faucet placement. If the cabinet is out of level, we shim and shim until the top sits flat. This visit takes about 30 to 45 minutes, and you get a written price before we order anything.
Tools & methods
Tools and methods we use on every install
Wet saw
Cuts quartz and granite slabs with a clean edge and minimal dust. We cut outside or with water suppression so your home stays clean.
Laser level
Checks the cabinet box for level and square before templating. A top set on an out-of-level box will rock and eventually crack at the sink.
Oscillating multi-tool
Handles tight cutouts around the sink and faucet holes where a saw will not fit. Also used to trim the old caulk line during removal.
Caulking gun
Applies a continuous bead of silicone caulk under the top and along the backsplash seam. A steady bead is what keeps water out of the cabinet.
Moisture meter
Confirms the substrate and cabinet box are dry before the new top is set. Setting a top over damp wood traps moisture and grows mold.
Stud finder
Locates blocking for backsplash attachment and any wall-mounted fixtures. Keeps fasteners in solid wood instead of drywall.
Real results
Before and after.
Countertop Installation
Stained laminate to quartz in Highland Area
A 1970s ranch bathroom had the original laminate top with a brown stain ring around the sink and a swollen front edge. The cabinet side was soft to the touch and the shutoff would not close all the way.
After: We replaced the shutoff, set a white quartz top with an undermount sink, and installed a new Moen faucet. The cutout was dead center and the caulk line was smooth. Install took four hours and the water test passed first try.
Book this service →
Countertop Installation
Cracked tile top to granite in Old Town
A tile vanity top had two cracked tiles at the sink cutout and black grout along the backsplash. Water had been getting behind the top and the drywall was soft for about 8 inches.
After: We removed the tile, replaced the damaged drywall, and set a granite top with a silicone caulk seam. The new cutout was fully supported. The homeowner picked a honed finish that hides water spots.
Book this service → Countertop Installation
Double vanity refresh in Pocatello Creek
A master bathroom had two mismatched tops, one quartz and one laminate, with a visible height difference at the seam. Both sinks drained slowly and the left faucet wobbled.
After: We templated both bowls and set a single continuous quartz top with matched veining. Both drains and supply lines were replaced, and the faucets were re-set flat. The seam is invisible and both sinks drain fast.
Book this service → Problems we solve
Problems a new Pocatello bathroom countertop fixes
Most vanity tops fail the same way: water gets in, the material swells or stains, and the damage spreads downward. Here is what we see and how we stop it.
Ask a pro →Laminate swelling around the sink
We remove the swollen top, inspect the cabinet for soft spots, and set a non-porous quartz or granite top with a sealed cutout. The new surface cannot absorb water, so the failure mode is gone.
Black grout and mold at the backsplash
We pull the top, check the drywall behind it, and replace any damaged section. The new top gets a silicone caulk seam instead of grout, which stays flexible and sheds water.
Cracked tile around the sink cutout
We template the cutout to the exact sink and support the full perimeter of the opening. A moisture meter confirms the substrate is dry before the new top is set.
Faucet wobble and leaking shutoff
We tighten or replace the faucet and swap the shutoffs while the top is off. New Moen or Delta fixtures seat flat on a level deck, and the supply lines get pressure-tested before we close up.
Proof you can check
Licensed, insured, and local
- EPA Lead-Safe Certified Firm · U.S. Environmental Protection Agency
- State of Idaho Plumbing License · State of Idaho Division of Occupational and Professional Licenses
- TCNA Tile Installation Certification · Tile Council of North America
- OSHA 10 and OSHA 30 · Occupational Safety and Health Administration
- ADA Compliance Certification · ADA National Network
Most single-vanity jobs run $650 to $1,900 in 2026, depending on material and size. Laminate sits at the low end, quartz and granite in the middle to upper range. Add $150 to $400 if you want a new faucet, sink, or taller backsplash. Double-vanity tops run $1,400 to $3,200. We quote the full job before ordering material.
Quartz is the best all-around pick for Pocatello bathrooms. It is non-porous, so it shrugs off hard water and soap scum, and it never needs sealing. Granite is a close second if you want natural stone and do not mind sealing it once a year. Laminate is the budget option, but it swells if water sits at the sink seam.
Install day itself runs 3 to 5 hours for a single vanity. The full timeline from template to finished top is usually 7 to 14 days, because slab fabrication takes 5 to 10 business days. If you pick an in-stock slab, we can sometimes compress that to under a week. Double vanities add about 2 hours on install day.
Quartz does not need sealing, ever. Granite should be sealed once a year, and more often if you use abrasive cleaners. We apply the first sealer coat at install. To test whether granite needs a re-seal, drip water on it: if the water darkens the stone instead of beading, it is time. A $15 sealer kit handles it.
Ready when you are
Get your bathroom countertop installation Pocatello ID quote today
Call +19863369053 and we will measure your vanity, show you slab options, and give you a written price before we order material. Licensed, insured, and local to Bannock County.
Get a Free Quote +19863369053 →
Request an appointment
Contact our Pocatello bathroom crew
Call us or send a message and we will get back to you the same business day. We schedule estimates Monday through Friday and can usually get to a Pocatello address within a few days. Tell us what is going on with the bathroom and we will tell you what it takes to fix it.
Call anytime+19863369053Email the officeinfo@bathroomremodelpocatelloid.com
Office hoursOpen 24 hours · 7 days a week